FCC Class B Verification

REQUIREMENTS FOR FCC PART 15 CLASS B DIGITAL DEVICE TYPE OF EQUIPMENT AUTHORIZATION -“VERIFICATION”

• A detailed test report of measurements showing FCC Part 15 Class B compliance to be kept on file. Compatible electronics, Inc. will provide this report after the testing.
• Information to the user in the operations manual of the unit regarding interference potential of the device. Refer to attached example.
• Labeling requirement for the Class B computing device. Refer to attached page on labeling requirement.

SAMPLE FCC STATEMENT TO BE INCLUDED IN USER’S MANUAL INSTRUCTION TO THE USER

This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment and receiver

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

• Consult the dealer or an experienced radio/TV technician for help

This equipment has been verified to comply with the limits for a class B computing device, pursuant to FCC Rules. In order to maintain compliance with FCC regulations, shielded cables must be used with this equipment. Operation with non-approved equipment or unshielded cables is likely to result in interference to radio and TV reception. The user is cautioned that changes and modifications made to the equipment without the approval of manufacturer could void the user’s authority to operate this equipment.

LABELING REQUIREMENT FOR USA FCC PART 15 CLASS B DIGITAL DEVICE

The unit should have a permanently attached label in a conspicuous location with the following statement:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: The FCC does not specify the size of the label or the lettering thereon. The only requirement is that the text be legible.